Small Block Chevy Steel V8 Monza Vega Style Exhaust Headers Sanderson CC13AP-P
Small Block Chevy Steel V8 Monza Vega Style Exhaust Headers Sanderson CC13AP-P. The CC13AP Plain Steel header set is an inside-the-frame rail design that fits Chevrolet Monza and V8 Vega applications using the small block Chevy engine with angle plug cylinder heads.
(Also compatible with similar GM H-chassis applications). The vehicle's steering shaft routes between the engine block and header tubes on this application. The use of solid motor mounts, engine plates, or the installation of a torque limiter is strongly recommended to prevent the engine from shifting in the engine bay.
Inadvertent engine movement could cause the steering shaft to bind. Comes with all hardware necessary for installation. Engine: Small Block Chevy 265-400 Primary Tube Diameter: 1-1/2?16-Gauge Primary and Collector Tube Thickness. Patented Flange Design Requires NO Gaskets. Tightest Fitting Header Available Anywhere! This header offers 1½ primary tubes, which is good for about 350HP on a casually used engine application.
The vehicle's steering shaft will run between the engine block and header on this application. The use of solid motor mounts, engine plates, or the installation of a torque limiter is strongly recommended to prevent the engine from shifting would may cause the steering to bind. The Patented Leak-Free Design that Sanderson Headers offer you is the.
Leak-free flange design on the market.. Do Not Attempt To Use Flange Gaskets! The raised flange on the Sanderson Headers will buckle the gasket during tightening and actually cause a leak! Emissions legal on pollution-controlled motor vehicles.
It is the purchaser's responsibility to verify local regulations for compliance. The best thermal protection for your headers is our Aluminized Ceramic Coating that is available for every Sanderson Header. When sitting in driver's seat and engine in front of you, the LEFT header would be the Driver's Side on LH drive vehicles; coincidently, means the RIGHT header is on the passenger side. See the detail image that describes engine sides. If needed sooner please contact our office.